Corghi CompactLine Serie Manual De Uso página 101

• insert the two screws provided into the holes on the wheel contact flange;
• tighten the screws on the adapter making sure that it rests on the flange correctly;
• mount the motorcycles shaft on the adapter;
• mount the wheel after selecting the centring cones (one for each side of the wheel),
tighten with the appropriate ring nut using the spacers necessary for coupling the secur-
ing cones to the threaded part of the shaft.
IMPORTANT: the wheel must be fixed to the flange so as to avoid any movement of the
two during the spin or braking phases.
- Select the Balancing programme icon
the MOTORCYCLE environment.
- Fit the appropriate extension on the inner measuring arm, specifically extension A on
machines with no weight holder or extension B on machines with weight holder (Fig. 21 a).
- Set the wheel data as usual.
- Proceed as described for dynamic balancing.
Proceed as follows to balance motorcycle wheels dynamically using adhesive weights:
- follow the instructions for mounting the motorcycle adapter described in the MOTOR-
CYCLE DYNAMIC PROGRAMME;
- follow the instructions above for the "Motorcycle Dynamic" programme;
- perform a spin;
- at the end of the spin, select the Balancing programme icon
ENTER button until the required programme is selected;
- for the application of the adhesive weight, always use 12 o'clock as a reference regardless
of the setting in Configuration of Adhesive Weight Application Position.
Best results can be achieved if the adhesive weights are positioned with the outer edge
being flush with the rim edge.
Operator's manual EM 9280 - EM 9280 C CompactLine
21
Motorcycle ALU programme
and then press the ENTER button to set
21A
UK
and press the
101