8.2.2. Rear bin: replacing
•
Remove the back wheels
•
Remove the rear bin
•
Unscrew the two pins fixing the flap (fig. F, ref. 3).
•
Grip the flap and pull (fig. F, ref. 4)
•
Replace the flap, insert the two pins in the relative holes
•
Screw up the fixing pins and assemble the machine.
8.2.3. Centre brush: replacing
•
Remove the front bin (fig. A / B, ref. 2)
•
Unscrew the screws fixing the brush to the shaft.
•
Remove the brush
•
Replace the brush making sure the orientation of the bristles is correct.
8.2.4. Side brush: replacing
•
Lift the front of the machine
•
Unscrew the screw (fig. D, ref. 1), remove the worn brush
•
Install the new brush and fix it with the screw (fig. D, ref. 1).
•
Unscrew the two screws (fig. E, ref. 1), adjust the height of the brush and tighten
the screws.
Never use a fuse with a higher amperage than specified.
If a fuse continues to blow, the fault in the wiring, boards (if present) or motors must be
identified and repaired. Have the machine checked by qualified personnel.
8.2.5. Fuses: replacing
•
Turn the key switch (fig. C, ref. 1) to the "0" position.
•
Rotate the cowling to access the machine compartment
•
Remove the fuse holder cover
•
Check the fuses.
•
Replace with a new fuse.
•
Close the cover again
Fuse table: For the complete fuse table, see the spare parts catalogue.
8.2.6. Side brush belt: replacing
•
Rotate the top cowling.
•
Remove the pulley (fig. G, ref. 2) belt (fig. G, ref. 1)
•
Unscrew the fixing pin (fig. G, ref. 3) and side arm hooks (fig. G, ref. 4) from the
idle toothed ring.
IMPORTANT
ENGLISH
18
