•
Remove the belt (fig. G, ref. 1) from the side arm (fig. G, ref. 4)
•
Replace the belt
•
Attach the side arm (fig. G, ref. 4) to the idle toothed wheel again.
•
Screw up the pin (fig. G, ref. 3).
•
Fit the belt (fig. G, ref. 1) onto the pulley (fig. G, ref. 2)
8.2.7. Drive belt 512-712: replacing
•
Rotate the cowling.
•
Remove the belt (fig. H, ref. 1) from the groove of the pulleys.
•
Fit the new belt (fig. H, ref. 1) onto the pulleys.
8.3.
Regular maintenance
8.3.1. Daily operations
•
empty the bins.
•
make sure there are no wires or straps rolled around the centre brush.
•
recharge the batteries according to the procedure described.
8.3.2. Weekly operations
•
check for wear of the FLAPS. If necessary, replace.
•
Check the condition of the suction air filter and make sure it is undamaged. If
necessary, replace.
•
check the level of battery electrolyte and top up with distilled water if necessary.
8.3.3. Six monthly operations
•
Have the electricity circuit checked by qualified personnel.
ENGLISH
19
