Rear Bin: Replacing; Centre Brush: Replacing; Side Brush: Replacing; Fuses: Replacing - IPC 512 Serie Manual De Instrucciones

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 117

8.2.2. Rear bin: replacing

Remove the back wheels
Remove the rear bin
Unscrew the two pins fixing the flap (fig. F, ref. 3).
Grip the flap and pull (fig. F, ref. 4)
Replace the flap, insert the two pins in the relative holes
Screw up the fixing pins and assemble the machine.

8.2.3. Centre brush: replacing

Remove the front bin (fig. A / B, ref. 2)
Unscrew the screws fixing the brush to the shaft.
Remove the brush
Replace the brush making sure the orientation of the bristles is correct.

8.2.4. Side brush: replacing

Lift the front of the machine
Unscrew the screw (fig. D, ref. 1), remove the worn brush
Install the new brush and fix it with the screw (fig. D, ref. 1).
Unscrew the two screws (fig. E, ref. 1), adjust the height of the brush and tighten
the screws.
Never use a fuse with a higher amperage than specified.
If a fuse continues to blow, the fault in the wiring, boards (if present) or motors must be
identified and repaired. Have the machine checked by qualified personnel.

8.2.5. Fuses: replacing

Turn the key switch (fig. C, ref. 1) to the "0" position.
Rotate the cowling to access the machine compartment
Remove the fuse holder cover
Check the fuses.
Replace with a new fuse.
Close the cover again
Fuse table: For the complete fuse table, see the spare parts catalogue.

8.2.6. Side brush belt: replacing

Rotate the top cowling.
Remove the pulley (fig. G, ref. 2) belt (fig. G, ref. 1)
Unscrew the fixing pin (fig. G, ref. 3) and side arm hooks (fig. G, ref. 4) from the
idle toothed ring.
IMPORTANT
ENGLISH
18
Tabla de contenido
loading

Este manual también es adecuado para:

712 serie512 e512 s512 e rider512 s rider712 e ... Mostrar todo

Tabla de contenido