Maintenance Of The Cutting Blades; Sharpening The Cutting Blades - TRAPP TRP 30 Manual De Instrucciones

www.trapp.com.br

Maintenance of the cutting blades

TRAPP shredders leave the factory with 2 cutting
 
blades sharpened this prolongs the useful life of
the cutting edge
The 2 blades should be sharpened when the
 
cutting edge is worn.
Whenever sharpening, make sure that you remove
 
the same amount of material from each blade, so
that you do not affect the balancing if the shaft
assembly and consequently cause vibrations.
The blades should be replaced whenever they do
 
not permit the perfect sharpening.
To sharpen the blades, proceed as follows.
 

Sharpening the cutting blades

Sharpening the cutting blades
Models TRP 400E e 400G
1. Raise the drive belt tension lever to facilitate the rotation of the disk.
2. Upon opening the lid of the shredder body (1) rotate the positioning of the 2 discs so that it is easy to remove
the screws (2) and lock washers (3) and remove the knife (4) and carry out the sharpening.
For assembling the equipment, the assembly sequence must follow the exploded drawing.
 
Models TRP 30 and TRP 40
6
3
Loosen the knob (1) and flat washer (2) to the
 
point where the hook (3) releases the cover (4),
thus providing access to the blades and the disc.
Loosen the screw (4) and lock washer (5) releasing
 
the knife (6) so that the sharpening can be done
as needed.
1
4
3
2
5
4
1
2
53