Tabla de contenido
Idiomas disponibles
Idiomas disponibles
www.trapp.com.br
9. Turn the disk to the next axle of the
hammers, and repeat previous instructions.
10. After turning all hammers over, the side cover
and the upper outlet shall be reassembled.
3
7
7
Attention!
The hammers shall be replaced for new
ones when both sides are worn out.
When funnels (feed and outlet) are
disassembled to change a tool, to
remove the material that caused the
clogging, turn the equipment off.
Sharpening cutting blades
When cutting blades are worn, you will obtain
poor cutting quality. Sharpening of the cutting
blades shall be done whenever you observe
that the cutting edge is worn. Sharpen the
blades as follows:
1. Remove side cover (locking of square rods) (1).
2
6
5
1
2. Loosen the two hexagon nuts and remove
service opening protection (2).
3. Remove upper outlet (3).
4. Turn the disk with your hands until the
blades find the service opening (4).
5. Loosen the screws that fasten the cutting
blade and remove it (5).
6. Turn the disk to the next cutting blade, and
repeat the previous instructions.
7. Sharpen the cutting blades. Be careful to
remove the same amount of material from
each blade to keep the balance of the disk
assembly and to avoid vibration.
8. After sharpening the cutting blades, fix them
and replace service opening protection.
9. The side cover and the upper outlet shall be
reassembled.
3
4
Attention!
The cutting blades shall be replaced
whenever optimum sharpening is no longer
possible.
2
5
1
47
Tabla de contenido
