Maintenance Instructions - TRAPP TRP 30 Manual De Instrucciones

To attach the rubber shockers, proceed as shown
 
in the illustration at the side.
Counter cutting blade
Periodic tightening of screws as well as the
adjustment of the counter cutting blades are
essential. The adjustment is done by loosening the
hexagon nut (1) as in Figure 1 and by displacing
the counter cutting blade until the cutting blades
pass at a distance of approximately 1.5 mm
for the TRP 30 and TRP 40 and 4.0 mm for the
TRP 400E/G (Figure 2).
The counter cutting blade shall be substituted when
worn out.
Figure 1
50
Rubber Cushions

Maintenance Instructions

1
Blades
TRP 30 = 1.5 mm
TRP 40 = 1.5 mm
TRP 400E/G = 4.0 mm
Figure 2
12
www.trapp.com.br
Rubber cushions
Counter cutting blade