Personal Safety - TRAPP TRP 30 Manual De Instrucciones

3 - Personal safety

Beware with what is going on and use common
 
sense when operating the equipment. Do not
use it when you are tired, distracted or under the
influence of drugs, alcohol or medicine. A slight
distraction may result in a serious injury.
Do not leave shredder running and/or
 
unattended.
Do not turn on shredder if feeding funel is open.
 
Wear protection equipment. Always wear
 
goggles. Wearing protection equipment like
gloves, shoes, and ear plugs increases your
protection and reduces the risk of an accident.
Wear proper clothes. Wear neither loose clothes
 
nor jewelry.
Take precautions against accidental running.
 
Make sure the switch (TRP 40/TRP 400E) is set to
"off" before plugging the equipment in. Failure to
do so may cause a serious accident.
Remove all objects before turning on the
 
equipment. A tool or any other object stuck in
the movable parts of the equipment may result in
an injury.
4 - Use and care
Do not overuse the equipment. Use it in the right
 
way and for the purposes described in this manual
for better performance and safety while working.
Do not grind rock, glass, metals, plastics,
 
chemical products or other items that can
damage the shredder mill.
Should the shredder not achieve its full power
 
capacity, contact service dealer or an electrician
to verify the condition of your electric power
source to avoid motor burn-out by overload.
If after turning on shredder, motor does not
 
start, turn off immediately.
Make sure that the blades are spinning
 
clockwise to the machines TRP 400E and 400G
and counterclockwise for TRP 40. If they are
not turning in the direction as specified, contact
service dealer or an electrician to invert direction
of rotation.
Do not use the equipment if the switch does not
 
turn on/off (TRP 40/TRP 400E). The equipment
42
can not be controlled if the on/off switch is
damaged. A defective switch shall be immediately
repaired.
Switch off the circuit breaker, remove the fuses
 
or unplug the equipment before servicing or
substituting the blades. These safety preventive
measures reduce the risk of accidental operation
of the equipment.
Never put the equipment away with gasoline
 
in the tank (TRP 400G). If necessary, keep the
engine running until it turns off due to lack of
gasoline.
Fixing must be
 
technicians.
Preserve your equipment. Frequently check if
 
the movable parts are fixed, if any component
is damaged or check for any other condition
that may affect its optimum operation. Shall any
problem arise, fix it before using the equipment.
Many accidents are caused by lack of proper
maintenance.
Keep the cutting blade sharp and clean.
 
The blades keeps moving after the equipment is
 
switched off. Therefore be aware of that when
servicing.
Note:
do not use the fuel injector when the motor
is hot (TRP 400G).
Note:
according to the Brazilian standard
NBR 5410, it is compulsory to install a device
to protect against residual differential current
(DR device) in the electrical installation of your
residence. The function of the "DR" is to protect the
user against serious electrical shock risk (consult an
electrician).
5- Service
Call qualified professionals to service
 
the equipment. Use original parts only.
Always call TRAPP Authorized Service
Technicians. TRAPP is not responsible for
occasional accidents caused by the use of
spare parts that are not original.
www.trapp.com.br
executed by authorized