Cutting Blades Maintenance - TRAPP TRC-40 Manual De Instrucciones

4
7
8
9
11
38

Cutting Blades Maintenance

1
2
3
5
6
10
In order to execute the wiring, proceed as
described below:
Remove the bolt (1), the plain washer (2) the
 
upper blade (3), the intermediary blade (4)
and the intermediary blade (5).
Next, remove the separator of 16 mm (6),
 
and the intermediary blade (7).
Then, remove the hexagonal bolts (8), the
 
lockwashers (10), the hexagonal 6 nuts (11)
and the lower blade (9).
Execute the sharpening.
 
In order to assemble the unit, follow the
assembly sequence of the drawing exhibited at
the side.
ATTENTION!
Use
!
TRAPP ORIGINAL
PARTS.
TRAPP does not undertake
responsibility for eventual
damages caused to the
equipment, neither for
accidents that may occur
due to the use of non-
original parts.
www.trapp.com.br