Cutting Blades Maintenance - TRAPP TR 200 Manual De Instrucciones

TRAPP shredders leave factory with
 
temperate cutting blades prolonging cutting
durability.
Sharpen the cutting blades when the edge is
 
dull.
Whenever sharpening, be careful to remove
 
the same amount of material from each
cutting blade to keep balance and to avoid
vibrations of the axle unit.
The cutting blades shall be substituted
 
whenever optimum sharpening is no longer
possible.
In order to execute the wiring, proceed as
 
described below:
1. Remove the screw (1), the lockwasher
(2), the plain washer (3) and the upper
cutting blade (4).
2. Afterwards, remove the separator of
12 mm (5), and the lower cutting blade (6).
3. Then, remove the separator of 16 mm (7),
the hexagonal screws (8), the lockwasher
(9), the nut (10) and the lower cutting
blade (11).
4. Execute the sharpening.
In order to assemble the unit, follow the
 
assembly sequence of the drawing exhibited
at the side.
40

Cutting Blades Maintenance

ATTENTION!
Use
!
TRAPP ORIGINAL
PARTS.
TRAPP does not undertake
responsibility for eventual
damages caused to the
equipment, neither for
accidents that may occur
due to the use of non-
original parts.
2
4
6
11
9
www.trapp.com.br
1
3
5
7
8
10