Electrical Safety; Personal Safety - TRAPP TR 200 Manual De Instrucciones

2 - Electrical safety

Do not expose the equipment
 
(TR 200) to either rain or humidity.
Install the equipment in a dry place,
protected from weather conditions. Water
inside the equipment can damage the electric
circuit of the motor, besides increasing the
risk of an electric shock.
Before installing your TR 200, make sure
 
the electrical voltage in your property
coincide with the electric motor.
Connecting electrical cables in a different
voltage will cause immediate motor burnout
resulting in a loss of warranty.
For your safety, ground the equipment.
 
Failure to do so may result in an
accident, electrical shock or personal
injury.

3 - Personal safety

Beware with what is going on and use
 
common sense when operating the
equipment. Do not use it when you are
tired, distracted or under the influence
of drugs, alcohol or medicine. A slight
distraction may result in a serious injury.
Do not leave shredder running and/or
 
unattended.
Do not turn on shredder if feeding funel
 
is open. In this position the blades will lock.
Wear protection equipment. Always wear
 
goggles. Wearing protection equipment
like gloves, shoes, and ear plugs increases
your protection and reduces the risk of an
accident.
Wear proper clothes. Wear neither loose
 
clothes nor jewelry.
Do not be self-confident. Keep both feet on
 
the ground to keep balance.
Take precautions against accidental
 
running. Make sure the switch (TR 200) is
set to "off" before plugging the equipment
in. Failure to do so may cause a serious
accident.
Remove all objects before turning on the
 
equipment. A tool or any other object stuck
in the movable parts of the equipment may
result in an injury.
34
4 - Use and care
Do not overuse the equipment. Use it in
 
the right way and for the purposes described
in this manual for better performance and
safety while working.
Do not grind rock, glass, metals, plastics,
 
chemical products or other items that
can damage the shredder mill.
Should the shredder not achieve its full
 
power capacity, contact service dealer or
an electrician to verify the condition of your
electric power source to avoid motor burn-
out by overload.
If after turning on shredder, motor does
 
not start, turn off immediately.
Verify that the blades are running
 
counterclockwise. Should blades be
running clockwise, contact service dealer or
an electrician to invert direction of rotation
(TR 200).
Do not use the equipment if the switch
 
does not turn on/off (TR 200). The
equipment can not be controlled if the on/off
switch is damaged. A defective switch shall
be immediately repaired.
Switch off the circuit breaker, remove
 
the fuses or unplug the equipment before
servicing or substituting the blades
(TR 200). These safety preventive measures
reduce the risk of accidental operation of the
equipment.
Never put the equipment away with
 
gasoline in the tank (TR 200G). If
necessary, keep the engine running until it
turns off due to lack of gasoline.
Fixing must be executed by authorized
  technicians.
Preserve your equipment. Frequently
 
check if any component is damaged
or check for any other condition that
may affect its optimum operation. Shall
any problem arise, fix it before using the
equipment. Many accidents are caused by
lack of proper maintenance.
Keep the blades sharp and clean.


The blades keeps moving after the
 
equipment is switched off. Therefore be
aware of that when servicing.
www.trapp.com.br