Benelli TRK 502 Manual Del Propietário página 127

Instrument and control functions
djustment of the hydraulic brake action in
extension
It is possible to adjust the hydraulic brake
action in extension device using the adjust-
ment screw.
Turn it in direction "2" to increase the brake
EN action; turn it in direction "3" to reduce it.
3
1
3
1. Adjusting knob.
2. Increase braking action.
3. Decrease braking action.
NOTICE
To avoid damaging the mechanism, do not
try turning over the maximum or minimum
setting.
Always have the shock absorber adjusted
by a Benelli assistance centre.
WARNING
This shock absorber assembly contains hi-
ghly pressurized nitrogen gas. Read and
understand the following information be-
fore handling the shock absorber assem-
bly.
• Do not tamper with or attempt to
open the cylinder assembly.
• Do not subject the shock absorber
assembly to an open flame or other
high heat source. This may cause the
unit to explode due to excessive gas
pressure.
2
• Do not deform or damage the cylin-
der in any way. Cylinder damage will
result in poor damping performance.
• Do not dispose of a damaged or worn-
out shock absorber assembly your-
self. Take the shock absorber assem-
bly to a Benelli dealer for any service.
Adjustment of the hydraulic brake action
in compression (only for TRK502X)
It is possible to adjust the hydraulic brake
action in compression using the adjustment
screw.
Turn it in direction "2" to increase the brake
action; turn it in direction "3" to reduce it.
1. Adjusting knob.
2. Increase braking action.
3. Decrease braking action.
NOTICE
To avoid damaging the mechanism, do not
try turning over the maximum or minimum
setting.
Always have the shock absorber adjusted
by a Benelli assistance centre.
3 - 14