Benelli TRK 502 Manual Del Propietário página 118

Speedometers Indicates the vehicle's speed in
km/h or mph. To pass from one to the other,
press the "RESET" button.
Total/partial kilometre counter
The total kilometre counter shows the total
distance covered in kilometres.
Set in the mode instrumentation "TRIP A /
TRIP B" with the "SELECT" button.
The partial kilometre counter (TRIP A/TRIP B)
shows the distance covered since the last re-
set in kilometres.
The partial kilometre counter can be used to
estimate the possible distance to cover with a
full tank of fuel. This information may make it
possible to schedule future fuelling stops.
RESET/SELECT buttons
Buttons to set vehicle data.
Press the "SELECT" button to see the partial or
total kilometres.
When viewing partial kilometres (TRIP A/
TRIP B), it is possible to reset them by holding
down the "RESET" button for 3 seconds.
Transmission gear display
The transmission gear display shows the se-
lected gear.
This model is equipped with 6 gears.
Anti-lock Brake System (ABS) warning light
When the control panel is switched on, the
ABS diagnostic warning light will remain on
until the motorcycle reaches a speed of about
5 km / h. Once this speed is exceeded, the ABS
diagnostic indicator will go out.
ABS system error: if any type of error is de-
tected and stored, the ABS diagnostic lamp
will be on and remain on.
The ABS diagnostic warning light will switch
off when the instrument panel is switched off
/ on or when the vehicle exceeds the speed of
about 5 km / h.
WARNING
Usually the ABS diagnostic light stays on
when the instrument panel is switched on
and turns off when the vehicle speed is
above 5 km/h. Is the ABS diagnostic light
shows one of the following symptoms, one
or more faults may have been occurred on
the ABS system. In which event, take the
motorcycle to an authorized Benelli servi-
ce centre.
• The ABS diagnostic light does not go on
when the instrument panel is switched
on.
• The ABS diagnostic light will stay on
even when the vehicle exceeds the spe-
ed of about 5 km/h.
It is important to point out the fact that the
ABS is not active when the light is on, but the
braking system will continue working as a
3 - 5
Instrument and control functions
normal system not equipped with ABS.
In this situation, a hard braking may lock the
wheels, causing slip and loss of stability of the
motorcycle.
EN
3