BGS technic 9010 Instrucciones De Uso página 16

5. Front Cover Installation
5-1 Locate (B) onto the three holes of the crankshaft front oil seal. Then
locate (A) onto (B) and remove the seal by rotating in an anti-clockwise
direction.
5-2 Apply a 3mm bead of a suitable sealant around the contact face of
the front cover. Fit the front cover Loosely to the engine and retain in
place with a few bolts, fitted.
Note: To ensure correct alignment, the cover must be free to move on
the retaining bolts.
5-3 Fit (A) on to the crankshaft and into the engine cover, ensuring that
it is locating fully in the recess of the engine cover. Whilst maintaining
the position of the cover, fit and fully tighten all nuts and bolts that
attach the front cover to the engine.
Remove (A).
Note: A new oil seal comes with a sleeve to aid fitment over the
crankshaft.
5-4 Install the oil seal on to the crankshaft, ensuring that the seal retaining tabs are positioned behind
the timing cover. Assemble (B) with (A) and fit into the three holes of the oil seal. Rotate the seal
clockwise until it is locked in position.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
[email protected]
Fig.5
Fig.6
Fig.7
Fig. 8
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed