Malaguti SPIDER MAX GT 500 Manual Diagnóstico página 205

SPIDER MAX 500
Connect the diagnostic multimeter. Select the menu from the "ACTIVE DIAGNOSTICS" function.
Select the "INJECTOR" function.
Enable the function with the dashboard supply on and the motor not operating. The central unit controls
the fuel pump in continuous mode, while opening the injector. The injector openings will be repeated for
a few seconds.
Make sure the injector opening can be heard and wait for the multimeter reading.
Heard 4 injector openings. The
injection multimeter reads "test
ended with success".
Efficient injector control circuit.
Perform the hydraulic check of the
injector.
Select the menu from the "ERRORS" function and check whether the injector failure is the only
indicated anomaly.
All manuals and user guides at all-guides.com
Parameters
Immobilizer
Errors
Delete errors
Active diagnostics
CO calibration
Main
No injector opening
heard.
The injection multime-
ter reads "test failed".
79
Fuel pump relay
H.T. coil
Stepper motor
Rev. counter
Injector
Fan relay
5/8 Diagnostic check
No injector opening heard.
The injection multimeter reads
"test ended with success".
Efficient injector control circuit.
Verify again whether the injector openin-
gs can be heard and perform the hydrau-
lic check of the injector.
Throttle
Pressure
Water temperature
Air temperature
Battery voltage
Injector
Errors
12/04
B
5/6
•
1/3 A M