Feed Roller Assembly - HP LaserJet II Serie Manual De Instrucciones

HP 33440/HP 33449 COMBINED SERVICE MANUAL
Feed Roller Assembly
1. Remove the Main Body Covers, Front Support Plate, and DC Power Supply.
2. Remove the High-VoItage Power Supply Assembly.
3. Remove the screws (2) that secure each end of the Feed Roller Assembly (see Figure 6-26).
4. Lift slightiy and slide the assembly through the right side opening, being careful not to damage
the Paper Sensing Arm.
When reinstiling the assembly, be careful not to deform the lefi side grounding spring.
Do not attempt to replace any parts on the shaft. The entire assembly must be
replaced as a unit.
Note
Due to wear characteristics, the Separation Pad (see Registration Assembly
section below) and the Feed Roller Assembly should be replaced at the same time.
d
<\\l
'%kx-~
Screws
(One on Each
End of Shaft)
_-
/
Figure 6-26. Feed Roller
Assembly
6-31