HP LaserJet II Serie Manual De Instrucciones página 181

HP 33440/HP 33449 COMBINED SERVICE MANUAL
Table 7-2. Printer Messages (continued)
~SSAGE
S~A~ON DESCRIBED AND/OR AC~ON REQ~RED
68 ERROR Indiwtes a recoverable error has been detected in ~
(HP 33,449 Only)
(Non-Volatile M). Press c-j to clear, then verify the
Control Panel menu settings: one or more menu items have been
reset to their fatiory default settings during error recovery.
If this condition persists, replace the Interface/Formatter PCA,
68 SERWCE Indicates a ~
(Non-Volatfie W) failure has occurred
(HP 33440 and HP 33449) requiring replacement of the Interface/Formatter PCA. The printer
68 READY/SERWCE
mn be operated without ~ until that time. Press (~j
(HP 33449 Only)
to clear the display. All Control Panel values are set to their factory
default settings. The 00 READY message becomes 68 READY/SERVICE
to remind the user of the problem.
69 SERWCE Indimtes a timeout error has occurred between the
Interface/Formatter PCA and the Optional 1/0 PCA. Refer to the
1/0 Interface documentation.
Remove the Optional 1/0 PCA and retest. If the message persists,
replace the Interface/Formatter PCA.
70 ERROR The firmware mrtridge was not designed for this printer. Turn the
(HP 33449 Only) printer OFF, then back ON. If the error persisti, verify with the
mrtridge vendor whether the wrtridge was specifidly designed for
this printer.
71 ERROR The firmware mtiridge was not designed for this printer. Turn
:HP 33449 Only)
the printer OFF, then back ON. If error persists, veri~ with the
mrtridge vendor whether the mrtridge was specifidly desi~~d for
this printer.
72 SERWCE The font mrtridge was removed too quic~y after it was inserted.
:HP 33449 Only) Turn the printer OFF, then back ON. This message mn dso result
from a bad font mrtridge or bad connectors on the Formatter PCA.
79 SERWCE An unexpected error has been encountered. Document error
HP 33449 Only) message. Turn the printer OFF, then back ON. If the message
persists, proceed as follows:
Solid Remove memory PCAS and font macro, and persondi~
mrtridges one at a time. If the problem persists and the printer has
an Optional 1/0 PCA instiled, try a different interface (parallel or
serial) if possible.
If the problem continues, replace the Formatter PCA.
Intemittenti Have the customer remove, for a period of time, any
non-HP hardware/firmware products atiched to the printer. If the
problem continues during this test period, replace the Formatter
PCA.
Error message documentation should be returned with the
defective component.
7-17