HP LaserJet II Serie Manual De Instrucciones página 57

HP 33440/HP 33449 COMBINED SERVICE MANUAL
Table 3-5. HP 33449 Additional Configuration Menu Items
Item Ptinter Displa~ Pm
Choices
Press
Resolution RET=DAW*l
~:ep DARK ~DI~,
m to save
Enhancement
HGHT or OFF selection,
Page PAGEPROTECT=OFF*2 or-scro~
OFF, LTR, LGL, or A4 ~~j to efit, or
Protection
through items (=J to continue
1. An Aerisk (*) folloting an item indlmtes that the selection is saved.
2. p~e Protitiion is avdable only when optional additionrd memory is instiled.
Symbol Sets
A symbol set is usually selected during initial printer configuration. If a new default symbol set is
selected from the appropriate menu, it will cause the font selection menu item to revert to FONT
NUMBER=O. This is done bemuse the prnnterplaces dl fonts in the selected symbol set at the top
of its font list and reassigns font numbers. If, ~er speci~ng a new default symbol set, font Ois
not the desired default font a new Print Fonts routine should be performed and a new default font
selected from the resulting printout (see Section 3-5 for more information regarding Print Fonts).
With ROM-8 selected as the defatit symbol set, the symbol sets in Table 3-6 are arranged in
sequence as they are displayed on the HP 33440. The symbol sets in Table 3-7 which follows are
arranged in sequence as they are displayed on the HP 33449.
Auto Continue
When AUTO CONTINUE is set to ON,recoverable errors will take the printer off line and
display the message for 10 seconds before the printer will resume printing. When it is-set to
OFF,the printer will wait for the (-] key to be pressed before printing will resume. It is
recommended that AUTO CONTINUE be set to OFF
so
that any recoverable error messages show
until they are corrected. Note: If your printer is part of a network, remote, or spooling system,
AUTO CO NT=ON is the recommended setiing.
Interface Type
The me of serial interface (RS-422 or RS-232) is selected from the Control Panel on the HP
33449. To configure the HP 33440 for RS-422 communications, refer to Section 3-2.
Resolution Enhancement (HP 33449 Only)
Resolution Enhancement (RET) refines the print quality of characters and graphics by
"smooting" the fine gradations along the edge of the printed image. The RET option has four
choices: dark, medium, light, and off. The factory default seting is DARK.
caution
Some optional interface boards from vendors other than Hewlett-Packard are not
c!~lf
compatible with Resolution Enhancement. Emmples are the IntelR Visual Edge
kg
and the OP-Tek bserPort and bserPort GrayScale. When using one of these
products, set RET=OFF.
3-17