HP LaserJet II Serie Manual De Instrucciones página 49

HP 33440/HP 33449 COMBINED SERVICE MANUAL
Continue~set Key
~
Print Fontsflest
Key
(PRINT FONTS)
The
(CONTINUE/RESET)
key has two modes:
Briefly pressing the
(CONTINUE/RESET)
key clears most errors (except
hardware errors) and returns the printer to on-line status ~er an error
condition or device attendance request. The continue aspect of the key
overrides manual feed and media size requests and resumes printing
following recoverable error conditions.
Holding down the
(CONTINUE/RESET)
key until 07 RESETis displayed
(about two seconds) returns dl current printing settings to Control Panel
settings (see "Resetiing the Printer"). A Control Panel reset dso clears
tempora~ sofi fonts, temporary macros, and stored page data.
The
(PRINT FONTS/TEST)
key creates a font printout, a self-test printout,
and continuous self-test printouts. It has two basic modes:
Briefly pressing the
(PRINT FONTS/TEST)
key muses several pages to
be printed showing sample characters from dl available fonts. The
display W show 06 FONT PRINTOUT while the pages are printing. (See
Figure 3-5 (HP 33440) or Fignre 3-6 (HP 33449) for an example and
e~lanation of the font printout.)
Holding down the
(PRINT FONTS/TEST)
key until 05 SELFTESTis
displayed (about two seconds for the HP 33440 and about three seconds
for-the HP 33449) causes the printer to test ik built-in controller and to
create a test printout. During the test, dl the Control Panel indicators
light up. When the printing portion of the test begins, 06 PRINTINGTEST
is displayed. When the test is completed, 00 READY is displayed. (If an
error occurs during the test, an error message will be displayed instead.)
If the
(PRINT FONTS/TEST)
key is held down for at least five seconds (until
04 SELFTESTis displayed), test printouts will be continuously printed
until the (-] key is pressed (the [~] and
PRINT FONTS)
keys
@n dso be used). The 04 portion of the message will then flash and the
printer will return to on-line status when the page buffer is cleared (up to
six additiond pages may print).
Note
A reset is performed before and after the font printout and the self test. This
reset first prints any buffered data, then clears dl tempora~ fonts and temporary
macros.
Fom Feed Key
~
Pressing the ~~j key while the printer is off line and in a ready
stite tells the printer to print the contenti of the page buffer. If the last
page sent to the printer from the host is a partial page and the software
does not send a command to print this data, use the (~] key
to print the partial page. If there is no dah in the page buffer (i.e., the
FOW FEED indicator is OFF), pressing this key will have no effect.
3-9