Tabla de contenido
Idiomas disponibles
Idiomas disponibles
5. Operation
5.1- Clearing (unclogging)
(model with pulley and belt)
In case of 'clogging' the harvester, unclog the
feeding rollers using the inverter tool supplied
with the machine (figure on the side).
In the event of a 'clogging', immediately
turn off the tractor and remove the key
from the ignition.
NEVER AT TEMPT TO UNCLOG THE
MACHINE WITHOUT BEFORE TURNING
OFF THE TRACTOR AND REMOVING THE
KEY FROM THE IGNITION, THERE IS A RISK
OF SERIOUS ACCIDENTAL DAMAGE IF THIS
PROCEDURE IS NOT ADOPTED!
Keep the inverter tool always with the
machine, so it will be available whenever
necessary.
'UNCLOGGING' PROCEDURE:
Immediately stop the tractor and disconnect
1.
the power take-off;
Remove the key from the ignition;
2.
Check that the safety pin of the machine has
3.
broken. If it is broken, replace it with a new
one. To change the safety pin, see item 6.12
"SAFETY PINS".
Take the inverter tool (G) that is fixed on the
4.
machine arm;
Also take the tool handle (H) inside the tool
5.
box on the machine arm;
Remove the bolt and the flat washer (E) from
6.
protective cover;
60
ATTENTION!
Instructions Manual
INVERTER TOOL
G
H
Capítulos
Tabla de contenido
