Machine Disassembling; Demolishing The Machine; Disposing Of Harmful Substances - OEM TL 105 Manual De Uso

Chapter 7

7.1 - MACHINE DISASSEMBLING

In the event the machine shall be disassembled, to
install it again you shall proceed in the reverse order
in comparison with the instructions reported in "Instal-
lation" chapter.
DANGER
Before disassembling the machine or
demounting some machine components,
disconnect the power supply.
The machine assembling shall only be car-
ried out by skilled and authorized person-
nel.
ATTENTION
In case it is necessary to disassemble the
machine or demount some machine compo-
nents in a different way in comparison with
the written instructions, Company OEM or
its Agent shall be contacted - see addresses
on the third page of this publication.

7.2 - DEMOLISHING THE MACHINE

Proceed as described below if the machine is to be
scrapped for any reason:
• Disconnect the machine by complying with the instruc-
tions given in chapter "Installation" of this publication,
working in reverse order.
• Disassemble all possible machine components (cas-
ings, lamps, guards, handles, chains, motors, etc.)
and divide them according to their different nature
(eg.: pipes, rubber components, lubricants, solvents,
coating products, aluminium, ferrous materials, cop-
per, glass, etc.).
• Before scrapping the machine, notify the competent
authorities by written communication in compliance
with the laws in force in each individual country.
• After having received authorization from the above
mentioned authorities, dispose of the machine com-
ponents as prescribed by the current provisions in
merit.
EN - 40
Dismantling - Demolition - Disposal
To protect the environment, please
proceed in compliance with the local
laws in force.
When the machine can no longer be used or repaired, please proceed with
recycle and disposal.
Electrical equipment cannot be disposed of as ordi-
nary urban waste: it must be disposed of according
to the special EU directive for the recycling of electric
and electronic equipment (leg. decree no. 49 dated
14/03/2014 implementing the directive 2012/19/EU
RAEE and leg. decree no. 27 dated 4/03/2014 im-
plementing directive 2011/65/EU ROHS).
Electrical equipment is marked with a pictogram of
a garbage can inside a barred circle. This symbol
means that the equipment was sold on the market
after August 13, 2005, and must be disposed of ac-
cordingly.
Due to the substances and materials it contains,
inappropriate or illegal disposal of this equipment, or
improper use of the same, can be harmful to humans
and the environment. Improper disposal of electric
equipment that fails to respect the laws in force will
be subject to administrative fines and penal sanctions.
ATTENTION
Consult the next paragraph when disposing
of harmful materials (lubricants, solvents,
coating products, etc.).

7.3 - DISPOSING OF HARMFUL SUBSTANCES

Consult the provisions established by the Standards
in force in each individual country before disposing of
such substances.
ATTENTION
Any improper use by the Customer before,
during or after scrapping and disposing
of the parts of the machine, in respect
of the construction and application of
the applicable regulations, shall be the
customer's responsibility.
TL 105 - TL 108