Fitting The Gearmotor To The Guide; Mounting The Gearmotor To The Ceiling - King gates OVO Instrucciones Y Advertencias Para La Instalación Y El Uso

3.2.3 - Fitting the gearmotor to the guide

01. Fit the OVO gearmotor output shaft to the guide head [A] and
secure using 4 M6.3x38 screws [G] (fig. 14). The gear motor rotates
and can be positioned in three different ways (fig. 3).
14
G

3.2.4 - Mounting the gearmotor to the ceiling

01. On the basis of distances A, B and C in fig. 2 and 3, trace the
two fixing points of the front guide bracket at the centre of the door.
On the basis of the type of support surface, the front bracket can be
fixed with rivets, plugs or screws (fig. 15). If distances A, B and C
(fig. 2 and 3) are sufficient, the bracket can be fixed directly onto the
ceiling.
15
02. After drilling the holes in the relative points, leaving the gearmotor
on the ground, lift the guide from the front section and secure using
two screws, plugs or rivets, according to the installation surface.
03. Secure the brackets [H] using the screws [I] and nuts [L], select-
ing the hole most suited to ensure distance B, as shown in ( fig. 16)
16
L
I
04. Using a ladder, lift the gearmotor until the brackets are touching
the ceiling. Trace the drilling points and then return the gearmotor to
the ground.
05. Drill at the outlined points and then, using a ladder, lift the gear-
motor until the brackets are placed against the drilled holes (fig. 17)
and secure using screws and plugs suited to the support surface
(fig. 18).
6
A
B
0÷400 mm
H
17
18
06. Ensure that the guide is perfectly horizontal, then cut off the ex-
cess section of the brackets with a saw (fig. 19).
19
07. With the door closed, pull the cord to release carriage [M] from
the guide (fig. 20).
20
M
08. Slide the carriage until the leaf connecting bracket [N] (fig. 21) on
the upper edge of the door is perfectly perpendicular to the guide [O].