8.
Technical characteristics of the product
WARNINGS:
• All the technical characteristics shown refer to an ambient temperature of 20°C (± 5°C).
• King-Gates reserves the right to make changes to the product at any time it deems necessary, while still retaining the same functionality
and intended use.
Type
Power supply
Motor power supply
Maximum absorbed power
Current absorbed
Maximum speed
Operating temperature
Work cycle
Dimensions
Leaf maximum dimensions/weight
9.
Product durability
Durability is the average economic life of the product. The durability
value is strongly influenced by the severity index of the manoeuvres
performed by the automatism: that is the sum of all the factors
contributing to the wear of the product (see Table 1).
To establish the probable durability of your automation, proceed as
follows:
01. Calculate the severity index by summing up the percentage
values of the items in Table 1;
Leaf weight [Kg]
Leaf length [m]
Ambient temperature above 40°C or below 0°C or humidity over 80%
Solid door
Installation in a windy area
22
> 200 kg
> 300 kg
> 400 kg
500 kg
2 - 3 m
3 - 4 m
4 - 4.2 m
Modus 280
Electromechanical gear motor for hinged gates or doors
230Vac 50Hz
24 Vdc
280 W
1.25 A
1.5 rpm
-20 /+55°C
80%
165x250x306 mm
2.8m / 300kg
02. In chart 3 from the value just found, draw a vertical line to
cross the curve; from this point draw a horizontal line to cross the
"manoeuvring cycles" line. The determined value is the estimated
durability of your product.
The durability estimate is based on the design calculations and the
results of tests carried out on prototypes. In fact, being an estimate,
it does not represent any guarantee on the actual duration of the
product.
TABLE 1
Modus XL
230Vac 50Hz
24 Vdc
350 W
1.87 A
1.5 rpm
-20 /+55°C
80%
165x250x306 mm
4.2m / 500kg
Severity index
0%
5%
10%
20%
0%
10%
20%
20%
15%
15%