Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Commissioning
Commissioning can only take place after all the testing phases
of the gear motor and the other devices have been successfully
completed. For commissioning, refer to the instruction manual of
the control unit.
m
IMPORTANT – Partial or "temporary" commissioning is
prohibited.
6.
Maintenance
Regular maintenance is required to maintain a constant level
of safety and to guarantee the maximum life of the entire
automation.
Maintenance must be carried out in full compliance with the
safety requirements of this manual and in accordance with the
applicable laws and regulations. For the gear motor, scheduled
maintenance is required within a maximum of 6 months.
Maintenance operations:
1. Disconnect all power sources.
2. Check the state of deterioration of all the materials that make
up the automation with particular attention to the erosion or
oxidation of the structural parts; replace the parts that do not
give sufficient guarantees.
3. Check that screw connections are tightened properly.
4. Check the moving parts for wear and replace worn parts as
required.
5. Reconnect the power supply sources and carry out all the
tests and checks provided for in chapter 4.
For other devices in the system, refer to their instruction manuals.
7.
Disposal
This product is an integral part of the automation, and
therefore must be disposed of together with it.
As for the installation operations, even at the end of the product
life, dismantling operations must be carried out by qualified
personnel.
This product consists of various types of materials: some can be
recycled, others must be disposed of. Ask about the recycling or
disposal systems required by the regulations in force in your area,
for this category of product.
m
Warning! – some parts of the product may contain
polluting or dangerous substances which, if dispersed in
the environment, might cause harmful effects on both the
environment and human health.
As indicated by the side symbol, it is forbidden to dispose of this
product with household waste. Have it disposed
of separately, according to the methods set out by
the regulations in force in your country, or return the
product to the seller when buying a new equivalent
product.
m
Warning! – local regulations may provide for heavy
penalties for the illegal disposal of this product.
8.
Technical characteristics
of the product
m
WARNINGS:
• All the technical characteristics shown refer to an ambient
temperature of 20°C (± 5°C).
• King-Gates reserves the right to make changes to the product
at any time it deems necessary, while still retaining the same
functionality and intended use.
Power supply (Vac 50 Hz)
Motor power supply (Vdc)
Maximum absorbed power (W)
Maximum speed (rpm)
Maximum torque (Nm)
Work cycle (%)
Protection degree (IP)
Operating temperature (°C)
Gear motor weight (kg)
Dimensions (mm)
230
24
250
1
150
50
44
-20 ÷ +55
6,2
155x253x314 h
17
Tabla de contenido
