Inserting The Needle; Functions Of Panel - Texi Joy 48 Manual De Operación

INSERTING THE NEEDLE

Select a needle of the right type and size for the fabric to be
sewn.
CAUTION: Turn off the power before removing the needle.
1. Turn the handwheel toward you until the needle is at its
highest point.
2. Loosen the needle clamp screw.
3. Remove the needle.
4. Insert new needle into needle clamp with flat side to the
back and push it up as far as it will go.
5. Tighten the needle clamp screw.
NOTE: Do not use bent or blunt needles. Place needle on a flat
surface and check to see if bent.

FUNCTIONS OF PANEL

Pattern
indicator LED
Stitch width
indicator LED
LED display
Each time you press MODE button, you can realize the following functions:
1. Pattern selection/ stitch width mode.
2. Twin needle/ single needle mode.
Increase button
Decrease button
Texi Joy 48
Flat side
Needle
Twin needle
indicator LED
Mode selection
button
EN
71