Jungheinrich ETR 314 Manual De Instrucciones página 44

1.2.4 Error messages on Operator Display
Error Error text
1 LOW VOLTAGE
2 HIGH VOLTAGE
3 TEMPERAT
CONTR
4 VOLTAGE SUPPLY
5 ELECTR SYSTEM
6 ACCELERATOR
7 TURN OFF KEY
8 ELECTR SYSTEM
9 ELECTR SYSTEM
10 MAIN CONTACTOR
11-19 CONTROLLER
20 ELECTR SYSTEM
21-22 CONTROLLER
23 CONTROLLER CAN Controller error
24 CONTROLLER
25 INTERFACE / CAN
26 LIFT SENSOR
27 STEER ANGLE
28 SETPOINT ANGLE
29 SHIFT SENSOR
30 TILT SENSOR
31 SIDESHIFT SENS
32 MULTIP SENSOR
33 MULTIP SENSOR
34 CAN BUS
Explanation
Undervoltage
Overvoltage
TEMPERATURE of the
CONTROLLER
Broken wire, drive
potentiometer
Overvoltage
2 travel directions at the
same time
Lock switch
2 travel directions at the
same time
Body circuit breaker
defective
Main contactor defective Turn off / on, call service
Controller error
Armature attached
incorrectly
Controller error
Controller error
No logon from the
interface
Broken wire, lift
potentiometer
Broken wire, steering
angle potentiometer
Broken wire, steering
sensor
Broken wire, shift
potentiometer
Broken wire, tilt
potentiometer
Broken wire, ZH1
potentiometer
Broken wire, ZH2
potentiometer
Broken wire, ZH3
potentiometer
CANBus disrupted
Solution
Check battery voltage;
charge battery
Check battery voltage
Allow the controls to cool
Turn off / on, call service
Turn off / on, call service
Turn off / on, call service
Turn off / on, call service
Turn off / on, call service
Turn off / on, call service
Turn off / on, call service
Turn off / on, call service
Turn off / on, call service
Turn off / on
Turn off / on, call service
Turn off / on
Turn off / on, call service
Turn off / on, call service
Turn off / on, call service
Turn off / on, call service
Turn off / on, call service
Turn off / on, call service
Turn off / on, call service
Turn off / on, call service
Turn off / on, call service
E 13