Inspecting The Lift Chains; Checking The Hydraulic Oil Level - Jungheinrich ETR 314 Manual De Instrucciones

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

6.3

Inspecting the lift chains

Impermissible wear and external damage:
According to official regulations, a chain is worn when it has lengthened by 3% in the
area where it runs over the deflection pulley. We recommend replacing the chain at
2% for safety reasons.
The chain should be replace immediately in the event of any external damage,
because such damage eventually causes permanent breaks.
IMPORTANT If the industrial truck is equipped with two lift chains, both chains must always
be replaced. This is the only way to ensure that the load is distributed evenly
on both chains. When chains are replaced, the connection bolts between the
chain anchor and the chain must also be replaced. Use only new original
parts.
6.4

Checking the hydraulic oil level

– Open the door to the engine compartment.
– Preparing the industrial truck for
maintenance and servicing
(see section 6).
– Check the hydraulic fluid level in the
hydraulic tank on the side on the level
indicator (3).
NOTICE
The
completely lowered to read the
fluid level on the hydraulic tank.
– If needed, add hydraulic fluid of the
correct specification into the filler neck
(2)
(hydraulic
see section 5).
load
carrier
must
fluid
specification,
2
3
be
G 13

Hide quick links:

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Etr 320

Tabla de contenido