Commissioning - Jungheinrich ETR 314 Manual De Instrucciones

Moving the vehicle without the battery
– Pull out the battery connector.
– Disconnect the two-pole plug on the magnetic brake.
– Unscrew the brake loosening screws from the driving plate and screw them into the
holes in the magnetic brake.
NOTICE The brake is now ventilated without power. Without the battery, the vehicle
can be pulled or pushed.
IMPORTANT After moving is complete, the brake loosening screws need to be removed
again.
– Unscrew the brake loosening screws from the magnetic brake and screw them into
the holes in the driving plate.
– Connect the two-pole plug to the magnetic brake.
– Connect the battery plug.
– Turn on the EMERGENCY OFF switch and switch latch.
NOTICE The vehicle is now ready for use.
5

Commissioning

Qw W
The assembly of the vehicle at the use site, initial startup and the instruction
of the driver must be performed only by personnel trained by the
manufacturer. If more than one vehicle is delivered, ensure that only load-
handling equipment, masts, and basic vehicles with the same serial number
are assembled.
H 5