Medion LIFE X14308 Manual De Instrucciones página 169

Ocultar thumbs Ver también para LIFE X14308:
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 203
– Do not touch the plug with wet hands.
– Always hold the plug by its housing and
never pull it out of the socket using the
cable.
– Please note that the TV also continues to
consume power in standby mode.
.
If the device shuts down and restarts
due to an electrostatic discharge while
in USB mode (media player), optional
HbbTV mode or optional LAN/WiFi
operation (media player/portal), it will
not be able to independently restore
the last operating mode. Please restart
the respective media or applications.
The last user settings you entered
may not be restored following an
electrostatic discharge that causes
the TV to shut down because these
settings are only saved 5 minutes
after switching channels.
.
All multimedia devices, which are con-
nected to the corresponding ports of
the TV, must comply with the require-
ments of the Low Voltage Directive.
.. Handling batteries
WARNING!
Risk of explosion!
Batteries may contain combustible
materials and leak, heat up excessively,
ignite or even explode.
 Avoid improper handling of the batte-
ries to prevent damage to your device
and your health.
Please follow the safety advice below closely:
– Keep batteries away from children.
If batteries are swallowed, consult a doctor
immediately.
– Never charge batteries (unless they are de-
signed to be recharged).
– Never empty the batteries by means of
high power output.
– Never short-circuit the batteries.
– Never expose the batteries to excessive
heat, such as sunlight, fire or similar sourc-
es of heat!
– Do not dismantle or deform the batteries.
You could injure your hands or fingers, or
battery fluid could come into contact with
your eyes or skin. If this happens, rinse the
affected areas with plenty of clean water
and consult a doctor immediately.
– Avoid heavy impacts and vibrations.
– Always observe the correct polarity.
– Make sure that the plus (+) and minus (−)
poles are correctly inserted to avoid short
circuits.
– Do not mix up new and old batteries or
different types of batteries.
This could cause your device to malfunction.
In addition, the weaker batteries would dis-
charge too much.
– Remove spent batteries from the device
immediately.
– Remove the batteries from the device if
you do not intend to use it for a long peri-
od of time.
– Replace all of the old batteries in a device
with new batteries of the same type.
– Cover the contacts of the batteries with
sticky tape if you want to store or dispose of
them.
– If necessary, clean the battery and device
contacts before insertion.
– If the batteries have leaked, wear protec-
tive gloves and clean the contacts thor-
oughly.
EN
7
loading