Idiomas disponibles
Idiomas disponibles
3Transport and installation
3.1.0
Packing
Packaging includes a cardboard box with the following dimen-
sions:
Dimensions
Width
Height
Depth
IMPORTANT!
We recommend you to keep the packaging during the
warranty period.
3.2.0
Transport
The markings on the packing materials indicate how to handle
the machine during transport.
3.2.1
Unloading and handling the machine
The machine can be unloaded manually; no hoisting equipment is
required.
Be careful not to throw the machine off balance, let it
tip over and fall. Even a small damage would impair its
correct functioning.
3.3.0
Temporary storing
If the installation of the machine does not occur immediately,
store the machine in a dry and properly ventilated place.
• Apply an appropriate coating.
• Rubber parts must be protected against too low tempera-
tures. Never store them outdoors, not even for short peri-
ods.
If the machine is stored for long periods, gaskets or re-
taining rings may undergo hardening thus causing
leaks or seizures.
6
Keyline S.p.A.
TRANSPORT AND INSTALLATION
3.3.1
Characteristics of the place of installation
The key cutting machine must be placed on a smooth level bench
about 90 - 110 cm high, suitable for bearing the weight of the ma-
chine and keep it horizontal, thus avoiding vibrations and stress.
Allow a 30-cm clearance around and above the key cutting ma-
chine for correct functioning and maintenance.
500 mm
380 mm
3.3.2
Opening the package
500 mm
Remove the machine from the packing materials following the in-
structions below:
1. Cut the straps;
2. Remove staples;
3. Remove the machine from the carton.
3.3.3
Temperature and humidity
The machine should be used in rooms with a temperature range
of 0 - 40 °C (273 K - 313 K) and a relative humidity lower than 50 -
60%.
3.3.4
Working environment
The machine must be used in a place protected from bad weather
(rain, hail, snow etc.).
If the machine is used in places exposed to corrosion,
maintenance shall be scheduled in such a way as to
prevent extreme wear of the components.
Do not use the machine in explosive or partially explo-
sive atmosphere or in the presence of inflammable
liquids of gases.
3.3.5
Lighting
In the place of installation lighting must be appropriate, in order
to allow the correct use and maintenance of the machine.
EASY
3.3.6
Work station
The key cutting machine will be operated only by one operator
who will stand in front of the machine and do the following:
-
Hold his/her hands on the control levers during key cutting
operations;
-
Keep the work station tidy and free from objects that may
hamper regular machine operations;
-
Make sure that environmental conditions allow to work safely
(appropriate lighting, temperature and humidity);
-
Remove scrap and metal chips from the desk;
-
Keep unauthorised personnel out of the area.
3.4.0
Connections
3.4.1
Grounding
Key cutting machines EASY have been designed in compliance
with the safety legislation in force and feature appropriate safety
devices to prevent work accidents. In particular the machine was
built with materials that:
• are self-extinguishing;
• protect against electrocution.
The machine must be grounded through the centralised circuit of
the place of installation.
Warning:
Make sure that the main voltage is compatible with the
machine voltage.
Make sure that the motive power outlets are grounded.
Do not touch the machine when your hands and/or feet
are wet or humid.
Avoid any contact with grounded plates.
Man. cod. B410462FG
Copyright by Keyline - Italy
