5 Operating Instructions
"LEFT ARROW" key
"ENTER" key
"RIGHT ARROW" key
"LASER STOP" button
32
5.2
Switching the laser unit on and off
Once you have completed the installation procedure, press the "ENTER" key
to switch on the laser unit.
f the SIROLaser is not operated for more than two minutes, it automatically
switches to the standby mode. The unit can remain connected in the standby
mode.
To switch the laser unit off, select "OFF AREA". Then press "ENTER"
and disconnect the power cord.
5.3
Control panel
Figure 22:
Control panel
Navigate to the left. Parameters decrease. Quit certain menus.
Confirms, starts or stops a selected action following setup.
Navigate to the right (in all menus). Parameters increase.
You can stop the laser in an emergency with the "LASER STOP" button.
5.4
Electronic access key
The SIROLaser may be operated only by authorized personnel. When the
unit has powered up and its self-test has been completed, you will be
prompted to enter an access code. This code is your electronic key.
The access code comprises four numbers.
The code is:
To enter the access code, press the following keys consecutively:
Use the "RIGHT ARROW" key to scroll to one of the numbers.
Change from one selected number to the next one in the series by
pressing the "ENTER" key.
WARNING
Do not give the access code to unauthorized third parties. Risk of misuse of
the laser by unauthorized persons!
6 2 5 1
D 3485.201.01.10.02 03.2008
60 56 092 D 3485