Idiomas disponibles
Idiomas disponibles
Fig.1
Fig.2
Fig.3
19 - ENGLISH
6.3.3 SLUSH
-
With the machine at STOP, press the STOP and
SEMI-AUTOMATICO (SEMI-AUTOMATIC) keys
at the same time to access the slush production
program with consistency control and continuous
mixing (Fig. 1).
-
The SLUSH LED switches on to signal that one
has accessed the SLUSH mode.
-
The LEDs of the UP (▲),Conferma (Confirm)
(◄►) and DOWN (▼) keys light up and the
numbers relative to the consistency setting to be
configured, expressed by a numerical value
between 120 and 180, appear on the display:
press the UP (▲) and DOWN (▼) keys to
increase
or
decrease
consistencies correspond to high numbers, lower
consistencies correspond to low numbers.
The maximum programmable consistency value
is equal to 180 numbers but not all mixtures and
not all quantities can reach such a high
consistency value.
For
a
reduced
recommended to not select consistency numbers
close to 180.
-
Subsequently, press the Conferma (Confirm)
(◄►) key to start a new slush production cycle.
-
The GR1 message is viewed on the display for a
few seconds to confirm the slush cycle has been
selected
(Fig.
production,
the
numerical value is displayed.(Fig. 3).
-
After a few minutes and once the consistency
level selected during the programming phase
has been reached, an intermittent acoustic signal
warns the operator that it is possible to extract
the product. If this should not be immediately
possible, the machine will automatically see to
maintain the product over time without changing
its consistency any further.
-
During the maintenance phases of the reached
consistency
setting,
the
value.
amount
of
mixture
2);
subsequently,
instantaneous
consistency
the
indicator
Higher
it
is
during
of
the
