Saving Bolting Values; Connecting A Pc - Stahlwille 701 Manual De Instrucciones

Using the torque wrench
Proceed as follows to display the last peak value
again:
 Press the operating button once.
The last peak value is displayed.
 To save the displayed value, press the operating
button a second time whilst it is displayed.
The value is saved. The green LED flashes once.
Each value can only be saved once.

Saving bolting values

 To save the last torque value displayed, briefly
press the operating button twice.
The green LED flashes once. The value has been
saved.
Up to 2500 values can be saved. To evaluate the
values using the SENSOMASTER software, the
torque wrench must be connected to a PC. Further
information can be found in the software
instructions.

Connecting a PC

 Make sure that the torque wrench is switched off .
 Pull out the PC connection socket cover to the
side.
 Insert the micro USB connector to stop into the
PC connection socket in one movement.
 Insert the USB connector into the PC's USB
connection.
 Make sure that the connectors are firmly seated.
 Start the SENSOMASTER software installed on
the PC.
 Switch the torque wrench on.
The connection between the torque wrench and the
PC is established automatically.
Data can now be transferred between the PC and
the torque wrench. Further information can be found
in the software instructions.
Proceed as follows to disconnect the torque wrench
from the PC after data transfer:
 Remove the micro USB connector from the torque
wrench PC connection socket.
 Close the PC connection socket with the cover.
21