Working In User Function Mode - Stahlwille 701 Manual De Instrucciones

Using the torque wrench
 The red LED flashes.
Several short beeps are audible.
 The peak value which is achieved is shown on the
display for approx. 3 seconds. This time value can
be set using the SENSOMASTER software.
 To immediately save the displayed value, press
the operating button once whilst the value is
displayed.
The green LED flashes once.
Proceed as follows to display the last peak value
again:
 Press the operating button once.
The last peak value is displayed.
 To save the displayed value, press the operating
button a second time whilst it is displayed.
The value is saved. The green LED flashes once.
Each value can only be saved once.

Working in USER function mode

This function mode is only available if you have
undertaken corresponding pre-settings in the
SENSOMASTER software. These pre-settings must
then be transferred to the torque wrench. Working
in USER function mode does not differ from working
in the two other function modes.
20
 Whilst tightening, monitor the torque value on the
display.
 Tighten evenly and without interruption in the final
phase until you see the desired target torque
value.
During the bolting process in "User" function mode,
the following displays and signals are provided
depending on the settings which have been
undertaken:
 The current torque value is displayed.
 When you have reached 125 % of the nominal
torque value (overload), this is displayed:
 The torque wrench noticeably vibrates at
intervals.
 "Overload" is shown on the display.
 The red LED flashes.
Several short beeps are audible.
 When the set pre-warning torque is exceeded, the
yellow LED lights up.
 When the set torque is reached, the green LED
lights up.
 When the set tolerance range is exceeded, this is
indicated through the set optical, tactile or
acoustic signals.
 The peak value which has been reached is shown
on the display.