Pacojet 2 PLUS Manual De Instrucciones página 40

EN
Problem
Processing tool no longer
adheres to the blade holder
of the pacotizing shaft.
Repeat function not avai-
lable.
Any contamination of the
blade holder or blade head
of the processing tool will
increase the distance bet-
ween the two so that the
processing tool can no longer
be attached to the pacotizing
shaft.
The combination of splash
guard and processing tool
was attached to the Pacojet 2
PLUS before switching on.
40
Cause
Clean the blade holder of the
pacotizing shaft and the blade
head of the processing tool.
After doing this, if the pro-
cessing tool still can not be
attached, contact your service
partner.
1.) Switch off the appliance by
moving the mains switch (6)
to position "0" (see chapter
"6.5.2 Switching off the appli-
ance" on page 19).
2.) Remove the combination
of spray guard (8) and proces-
sing tool from the appliance
(see chapter "8.3 After paco-
tizing" on page 29).
3.) Wait 5 seconds and then
switch on the appliance
again (see chapter "6.5.1
Switching on the appliance"
on page 19).
4.) Attach the combination
of splash guard (8) and pro-
cessing tool to the appliance
again. The repeat function
should be available again and
programmable
(see chapter "8.2 Pacotizing"
on page 23).
Measure