Installation Instructions; Appliance Description - GGM gastro ELT Serie Manual De Instrucciones

66 |

INSTALLATION INSTRUCTIONS

ATTENTION!
Please refer to the initial pages of this manual for the figures mentioned in this chapter.

APPLIANCE DESCRIPTION

Sturdy stainless steel structure with 4 feet that can be
adjusted in height. External coating made in 18/10
chromium-nickel steel.
EN
Stainless steel cooking tank, oil temperature regulated by
a sensitive operating thermostat.
Ergonomic control knobs made of synthetic material.
The unit is equipped with a safety thermostat that
activates, deactivating the heating elements, in the event
that temperature gets too hot due to an error with the fryer
(for example, the unit is ignited without lling the tank
with oil). To restore the operation, use the disconnecting
switch to disconnect the power, let the unit cool down and
activate the button (3) marked with the "RESET" sticker.
(See g. 1). Then follow the instructions in the paragraph
"INSTALLATION" in order to start up the unit.
Before beginning the installation, remove the packaging.
A few parts are protected with an adhesive lm, which
should be removed carefully.
Remove any glue residual with the proper substances,
never use abrasive substances, refer to the instructions in
the paragraph "CARE OF THE APPLIANCE".
Location
The appliance should be installed in a well ventilated room
and, if possible, under a range hood. The appliance can
be installed on its own or alongside other equipment. If
the appliance is to be installed near in ammable walls, a
minimum distance of 150 mm around the sides and back
should be maintained. If this is impossible, take the proper
measure to ensure that the installation is safe, such as
tting tiles or heat-re ecting material to the walls.
Before connecting, read the technical plate of the unit to
check if the unit is tted for the available electrical power.
Room ventilation
The room where the appliance is installed must be tted
COOKING TANK
SAFETY DEVICES
INSTALLATION
with air intakes to guarantee the correct operation of the
unit and air exchange. The air intakes must be of adequate
dimensions, be protected by grids and positioned free of
any obstruction.
Caution - Warning
Do not install the appliance near any other units that can
reach high temperatures: the electrical components might
be damaged.
Law provisions, technical rules and directives
The manufacturer declares that the appliances comply
with the EEC directives and they have to be installed
according to the regulations in force. Before installing the
unit, take note of the following provisions:
- CEI provisions in force
- building regulations and local re prevention measures
- accident prevention regulations in force
- local Electric Energy Board regulations
INSTALLATION
Assembly, installation and maintenance must only be
carried out by companies authorized by local authorities
where the equipment is installed.
The manufacturer is not responsible for damage caused
by the improper installation or by an installation that does
not conform to these instructions.
Installation procedures
To level the unit, adjust the legs.
Attention
If the models ELT 12M-E, ELT 18M-E, E6F10-3MS, E6F10-
3M, E6F8-3M, E7F18-4M, E7F18-4MS, E7F10-4MS, E7F10-
4M, E9F22-4MS, E9F22-4M, SE9F22-4MSEL, SE9F22-4MEL
are installed as a single unit (not in a row), x the anti-tilt
bracket to the oor by using the proper anchor screws (see
g. 4). For the freestanding appliances that weigh more
than 40 kg and for the appliances equipped with the anti-
tilt bracket to the oor, always keep a minimum distance
of 50 cm from the side wall and 20 cm from the rear wall to
allow the assembly of the cable.
Warning!