36 +3.3 V Smart Media Card; 37 +3.3 V Smart Media Card With Write Protection In Place; Inserting The Smart Media Card; Smart Media Card Eject Button - DENTSPLY Multimat 2 Touch Manual De Instrucciones

6.14 Change tempering positions
This function can be used to change the tempering position.
Set new tempering position
1. Press the text field "Tempering" in the program twice. A selection screen is displayed.
2. Press sensor button "Tempering position".
3. Enter the new tempering position in "mm" with the numeric sensor keypad.
4. If the tempering position is lower than 100 mm, press the sensor button "Tempering positi-
on" again.
>
5. Press " ", and the program is displayed again.
Note: To permanently store the changed tempering position, the program must be saved
before the start. The new tempering position applies only for the changed program. All other
programs remain unaffected.
Change the tempering positions for ceramics only after consultation with the
manufacturer.
6.15 Display date or time
This function is used to set either the date or the time to be displayed in the program.
The factory setting is the date.
Changing the time or date display
1. Press the sensor button "Drying position".
2. Press the sensor button "Configuration".
3. Press the sensor button "Display date" or "Display time".
The display changes to date or time.
4. Touch sensor button "M" until the previous program is displayed.
6.16 Smart Media Card
(Smart Media Card REF 54 6023 0100)
(Main menu section 4.5)
Data are backed up on a Smart Media Card (see Figure 36 and 37). This card is a
dedicated storage medium. The cards come in two types:
• Cards for an operating voltage of +5 V, characterized by its left upper corner being cut off.
• Cards for an operating voltage of +3.3 V, characterized by its right upper corner being cut off
(see Figure 26). In addition, this card type is usually labelled with the letters "ID".
Either card at any capacity can be used for the Multimat 2 unit. Both types of cards
feature a write-protection field. If this field is covered by an adhesive conductive metal foil, the
Smart Media Card will be write-protected (see Figure 37).
Insert the Smart Media Card into the card reader with the medal surface facing back (outward,
toward you) (see Figure 38).
To remove the card, press the eject button (see Figure 39).
Using the Smart Media Card function, all or individual functions of the Multimat2 Touch can
be saved to the Smart Media Card and restored from the Smart Media Card to the Multimat2
Touch. The Smart Media Card, a dynamic storage medium, can be used
to save several hundred individual programs. This is particularly useful for additional
program backup.
All manuals and user guides at all-guides.com
Cut-off corner
Write-protection field
Figure No. 36: +3.3 V Smart Media Card
Write-protection field
covered
Figure No. 37: +3.3 V Smart Media Card
with write protection in place
Figure No. 38: Inserting the Smart Media
Card
Eject button
Figure No. 39: Media Card eject button
71