Removing The Target Pc Board - NAMCO bee panic Manual Del Operador

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 10
8-4

Removing the Target PC Board

1.
Remove the Target Assy.
2.
Remove the Target PC Board by gently pressing the Latch Hooks outwards, and
lifting the Target PC Board clear.
Target PC Board
3.
Reassemble in reverse order.
Note: When refitting the Target PC Board, align the pins with the holes in the
PC Board, and ensure that the Latch Hooks engage over the PC Board to
prevent damage to the light receiving sensor.
Check the direction of the Target PC Board before refitting. Refitted in
the wrong direction may damage the light receiving sensor. Make sure
that the sensor is reflected on the half mirror viewing from the front of
the Target Assy.
(see 8-3 page 60)
Latch Hooks
Light Receiving
Sensor Unit
Half Mirror
Target Assy
Page 62
Target Assy
(Front side)
Pin
Tabla de contenido
loading

Tabla de contenido