NAMCO bee panic Manual Del Operador página 78

4. Remove 4off security screws (M5x20), disconnect the connector, and remove the
Gun Assy.
Gun Assy
5. Reassemble in reverse order.
Note: In order to ensure the correct light output from the gun Assy, the
fibre-optic should be fitted as close as possible to the Xenon Tube.
When installing the fibre optic, be careful not to touch the Xenon tube
with your fingers or hands. If the Xenon tube is accidentally touched,
clean the area touched with alcohol. (Part No 95000031)
Insert the Fibre Optic until
it comes in contact with
the stopper in the holder
and install it so that it is as
close as possible to the
Xenon Tube.
Xenon PC Board
Security screws (M5x20)
Fibre Optic
Page 78
Connector
Holder
Xenon Tube