Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 10
8-12-3

Widthwise

1.
Remove 2off cap screws (M4x10).
2.
Disconnect the 3 connectors, and remove the Sensor Bracket.
3.
Remove 1off cap screw (M3x12), flat washer (M3), hex nut (M3) from the Sensor.
Replace the Sensor.
Hex nut (M3)
Flat washer (M3)
Prize Item Sensor
(3-pin connector)
Prize Item Sensor
(2-pin connector)
4.
Reassemble in reverse order.
Note: Ensure that a Sensor with a 2-pin connector (light emitting) and Sensor
with a 3-pin connector (light receiving) are installed alternately on each
side.
Prize Sensors
Connector (2-pin)
Page 73
Sensor Bracket
Cap screw (M4x10)
Cap screw (M3x12)
Connector (3-pin)
* Left side
Prize Item Sensor
(2-pin connector)
Prize Item Sensor
(3-pin connector)
Tabla de contenido
loading

Tabla de contenido