Lengthwise Rear - NAMCO bee panic Manual Del Operador

8-12-2 Lengthwise Rear

1. Remove 3off cap screws (M4x16).
2. Disconnect the 3 connectors, and detach the Sensor Bracket (A).
Cap screw (M4x16)
3. Remove 1off cap screw (M3x12), flat washer (M3) and hex nut (M3) from the
Sensor. Replace the Sensor.
Cap screw (M3x12)
5. Reassemble in reverse order.
Note: Ensure that the rear Prize Item Sensors have 2-pin connectors. (light
emitting)
Sensor Bracket (A)
Connectors (2-pin)
Hex nut (M3)
Flat washer (M3)
Prize Sensor
(with 2-pin connector)
Sensor Bracket (A)
Page 72
Cap screws (M4x16)