Tabla de contenido
Idiomas disponibles
Idiomas disponibles
9.2.2 Installing the lock on the box
The service hatch locking mechanism (bag G) is comprised of a key lock, a lock cam to be mounted on the
end of the barrel, and a striking place to be fastened to the wooden supporting brace.
•
Unscrew the hex nut on the barrel; remove the hex screw from the end of the barrel and thread the
o-ring onto the barrel ;
•
Push the lock barrel fully into the 20 mm diameter hole in the duckboarding. Replace the hex nut
underneath the duckboarding and tighten it ;
•
Place the lock cam on the end of the barrel, such that it is oriented toward the wooden supporting
brace when the lock is closed. Replace and tighten the hex nuts;
•
Fasten the strike plate to the vertical surface of the supporting brace using using 2 A2 SS hinge
screws 6 × 20 (bag G)
that the cam is positioned under the lip of the strike plate when the hatch is locked
Figure 34 – Lock and cam
10.
LADDER AND STEPS
10.1
Stainless steel ladder
Referring to the installation instructions, assemble the various sections
of the stainless steel ladder. When installing the hand rails, do not
forget the two rubber o-rings on the finishing trim.
Put the ladder in the pool on the coping module of your choice (except
the coping module over the skimmer). The ladder must be at least 30
mm from the corners of the pool. Remember that the in-pool ladder
and the wooden access ladder must be opposite each other. Once the
ladder position is selected:
•
adjust the position of the ladder making sure that it is straight and
that the bumpers are engaged against the interior wall. Mark the
locations to be drilled. Remove the ladder and drill 8 mm holes;
•
fasten the ladder in position using SS bolts, do not forget to put
the counter plate in position underneath the coping (supplied
seperately from the ladder). Tighten moderately.
•
slide 2 o-rings onto the tubes to hold the finishing trim in position.
WOODEN POOLS
(Figure
35), approximately 20 mm from the top of the supporting brace, such
BWT myPOOL POOL'N BOX
Figure 35 – Location of the lock striking plate
2021/02 - Version: D Code : 37311
O-ring
Escutcheon
plate
Disc
Figure 36 – Assembling the ladder
35/48
Capítulos
Tabla de contenido
