Mounting The Finishing Trim On The Supporting Braces; Fitting The Supporting Brace Pinch Sockets - BWT myPOOL POOL'N BOX Instrucciones De Montaje

6.4

Mounting the finishing trim on the supporting braces

Put the supporting brace finishing trims in position. They should be flush with the top of the pool wall.
Working from the inside of the pool, insert screws as shown in
5 × 80 A4 SS torx, threaded over 50mm (bag L) per half trim, that is a total of 24 screws. The 2 half trims
do not meet, the metallic brace will remain visible.
Should it be necessary to resize the trims (for example, if the pool is installed partially in-ground) orient the
cut surface upwards so that the cut side is not in contact with the ground.
6.5

Fitting the supporting brace pinch sockets

Fasten the two pinch sockets to the middle of the pool widths (at the positions shown in red in
and as shown in Figure
diameter of 10mm, using a concrete drill bit and a drill, or a percussion drill.
Fasten each pinch socket to the walls using an additional four torx hinge screws 6 x 20 in A2 SS (bag G)
per socket,
WOODEN POOLS
Figure 11 – Mounting the supporting brace finishing trim
12) using four studs M10 x 130 in A4 SS (bag B). To do this drill two holes with a
Figure 12 – Fitting the supporting brace pinch sockets
BWT myPOOL POOL'N BOX
Figure 11
Torx hinge screws 6 x 20
Studs M10 x 130
2021/02 - Version: D Code : 37311
using 3 countersunk screws
Figure 13
21/48