Installing The Lid O-Ring; Putting The Lid In Position - BWT myPOOL POOL'N BOX Instrucciones De Montaje

7.2.5 Installing the lid o-ring

7.2.6 Putting the lid in position

Incorrect fitting of the lid could entail:
• introduction of sand via the return fitting;
• leaks from the tank;
• water escaping from the waste port (drain). However, in filtration mode, it is normal for a small amount
of water to escape from the waste port. To prevent seepage, a 1/4 turn valve can be mounted on the
waste line (not supplied).
28/48
2021/02 - Version: D Code : 37311
Check that the upper, inner section of the tank and the
seal around the lid are clean.
Remove the plug from the collector pipe and fit the lid
onto the tank. The collector pipe should fit into the
diffuser under the lid.
Place the lid on the tank. Push the cover into the tank at one
point. Use your knee to keep applyng pressure at this point.
Potition both hands on the rim of the lid equidistant from the
knee and from each other (120 ° angle).
Bear down simultaneously with both hands to push the lid
completely into the filter tank. Maintain pressure on the lid until
the ring is screwed into position.
WOODEN POOLS BWT myPOOL POOL'N BOX