Mounting The Coping Brackets; Installing The Box Reinforcements - BWT myPOOL POOL'N BOX Instrucciones De Montaje

6.7

Mounting the coping brackets

Working from inside the pool, fasten the 15 wooden coping corbels in position using a SS torx countersunk
screws 5 × 80 threaded over 50 mm (bag L), as shown in
are flush with the top of the wall. Check that the corbels are perfectly level to facilitate the subsequent
installation of the coping.
6.8

Installing the box reinforcements

Place the 4 remaining 686 × 145× 45 mm reinforcements in position in the box, as shown in
These will support the duckboarding service hatch. The reinforcements should be positioned such that
they are flush with the top wall slats.
Side view
WOODEN POOLS
Figure 15 – Assembling the base of the plant housing portion of the box
Figure 16 – Location of the coping brackets
Figure 17 – Box reinforcement locations
BWT myPOOL POOL'N BOX
16. Ensure that the top of the corbels
Figure
View from above
2021/02 - Version: D Code : 37311
Figure 17.
23/48