Installation Of The Duckboarding; Assembling And Installing The Duckboarding - BWT myPOOL POOL'N BOX Instrucciones De Montaje

9.2

Installation of the duckboarding

9.2.1 Assembling and installing the duckboarding

The duckboarding acts as the box lid. Assemble the duckboarding modules as shown in
a gap of 2 mm between the slats. Use two A4 SS countersunk screws 5 × 40 threaded over 25 mm (bag
Z) at each end of the coping module.
Assemble the duckboarding
module with the lock using 4
coping modules 985 × 180 ×
28 mm, one of which is drilled
to house the the lock, and two
cleats, 650 × 70 × 28 mm.
Fasten two hinges to each duckboarding module at the cleats (see
Figure 33). The axle of the hinges must face upwards, and half of
this axle must protrude beyond the upper surface of the coping
module to allow the hatch to be opened properly. Use 3 A2 SS
countersunk screws 4 × 35 per hinge (bag Z).
Put the duckboarding modules in position over the box; the hole corresponding to the lock must be located
in the centre of the pool width. Using 6 countersunk screws 4 × 35 from bag Z, attach the duckboarding
hinges to the coping on the box side (marked U in
are correctly aligned.
34/48
2021/02 - Version: D Code : 37311
Figure 32 – Assembling the duckboarding modules
Figure 31) making sure that the coping and duckboarding
Assemble the
duckboarding module using 4
coping modules 985 × 180 ×
28 mm, 2 cleats 650 × 70 ×
28 mm and one cleat 435 ×
90 × 28 mm (use 4 screws for
attach this cleat).
Figure 33 – mounting the hinges on the
WOODEN POOLS BWT myPOOL POOL'N BOX
Figure 32. Leave
second
duckboarding