Installation Of The Metallic Coping Brackets; Finishing Trim - BWT myPOOL POOL'N BOX Instrucciones De Montaje

6.9

Installation of the metallic coping brackets

The metallic coping brackets are intended to support the coping and allow their attachment. Make sure that
they are correctly located. Position them such that they are flush with the top of the wall and make sure that
they are aligned with each other and with the wooden corbels.
Fasten 12 metallic coping brackets from the fastening element kit (6 righthand and 6 lefthand) to the top of
each supporting brace and on the box wall.
Their locations are shown in
of 72 screws.
In each of the corners, install 8 metallic support brackets (4 righthand and 4 lefthand), and 4 corner coping
brackets, as shown in
Use 6 A2 SS hinge screws 6 × 20 (bag G) per metallic support bracket and 4 A2 SS torx hinge screws 6 ×
20 (bag G) per corner metallic support bracket, that is a total of 64 screws.
6.10

Finishing trim

Use 3 convex head nails, 2.8 x 60 A2 SS (bag l) to fasten the 10 wooden finishing trims (1295 x 70 x 45) to
the edge of each wall. The nails should be evenly spaced and the finishing trim should be pre-drilled using
a drill bit with a diameter of 4mm
Apply adhesive tape (roll supplied) to the joins in the wall inside the pool to cover the screw heads
(Figure 21). This will protect the liner against screw heads that could damage it.
24/48
2021/02 - Version: D Code : 37311
Figure 18. Use 6 A2 SS torx hinge screws (bag G) per bracket, that is a total
Figure 18 – Fastening metallic support brackets to the top of the supporting braces
Figure 19
Figure 19 – Installing the metallic support brackets in the corners
(Figure 20).
WOODEN POOLS BWT myPOOL POOL'N BOX