BWT myPOOL POOL'N BOX Instrucciones De Montaje página 31

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Climb barefoot into the pool, check that the corners of the liner wall are properly aligned with the corners
of the pool structure. It is important to spread the liner out properly. Push the liner beading into the liner
locking track in the corners and then continue along the pool walls. Use half clothes pegs to block the liner
in position as you proceed (not provided), particularly in the corners
Figure 28 – Blocking the liner in position using half clothes pegs
The liner is deliberately manufactured 1.5% smaller than the dimensions of the structure to ensure that
there will be no wrinkles. It is therefore normal for it to be taut when laid. If there are wrinkles on the floor
of the pool, smooth these out as much as possible before filling the pool with water. Creases caused by
folding of the liner are normal and will disappear over time.
Check that the liner is correctly positioned (no excessive stress loading, no creases on the pool floor
or walls).
Should the liner need to be repositioned while fitting, never pull it along the track. Release the liner
and reposition it to avoid the risk of tearing.
Check that the liner is correctly engaged in the locking track, particularly in the corners both before and
during filling of the pool. Leave the half-pegs in position while filling the pool.
Turn the valve to CLOSED (see
and smooth out the liner on the pool floor, pushing any wrinkles towards the walls. Once the water level
rises above 10 cm, it will no longer be possible to smooth out any remaining wrinkles. Once the wrinkles
have been smoothed out, fill the pool to a depth of 45 cm, that is, 20 cm below the return fitting.
Should the liner come away from the liner locking track while the pool if filling, stop filling and reattach the
liner. Depending on the water level in the pool, it may be necessary to partially empty the pool in order to
reattach the liner.
WOODEN POOLS
Figure 27 – Unfolding the liner
Block the liner in position with half-pegs (not supplied) as you
progress around the pool, pay particular attention to the corners
Figure
paragraph 12.1.1, page
BWT myPOOL POOL'N BOX
28).
39), fill the pool to a depth of a few centimetres,
2021/02 - Version: D Code : 37311
31/48
Tabla de contenido
loading

Tabla de contenido