Assembling The Base Of The Plant Housing/ Storage Box - BWT myPOOL POOL'N BOX Instrucciones De Montaje

Insert the two wooden supporting braces 1285 x 145 x 45 into the pinch sockets and fasten them to the
pinch sockets using 6 screws per supporting brace that is 12 hinge screws 6 x 20 in A2 SS (bag G).
Working from inside the pool, fasten the wooden supporting braces to the pool wall. Screw each of the
9 full slats constituting the pool wall to the wooden supporting brace using 9 countersunk screws 5 x 80,
threaded over 50 mm, that is a total of 18 screws (bag L).
Figure 13 – Fastening metallic plates to the coping corbels
6.6

Assembling the base of the plant housing/ storage box

The portion of the box that will house the filtration group takes up half of the width of the plant housing/
storage box.
Install the two pine reinforcements, 686 × 145× 45 mm, that act as a support for the base of the box.
Respect the dimensions shown in Figure 14 in which the reinforcements are shown in red. Fasten them to
the walls using two 5 x 80 A4 SS torx countersunk screws threaded over 50 mm (bag L) at each end, that
is a total of 8 screws.
Figure 14 – Location of the box base supports
Place four reinforcement, 686 × 145 × 45 mm and one reinforcement 686 × 83 × 45 mm, across the two
transversal reinforcements previously installed.
Maintain a gap of 164 mm between the wall and the end of the reinforcing supports, as shown in Figure 14
Screw them onto the transversal supports as shown in using 10 A4 SS torx countersunk screws
Figure 15
5 × 80 threaded over 50 mm (bag L).
22/48
2021/02 - Version: D Code : 37311
WOODEN POOLS BWT myPOOL POOL'N BOX