Return Fitting Body; Assembling The Filter; Preparing The Valve - BWT myPOOL POOL'N BOX Instrucciones De Montaje

Glue the skimmer gasket to the front face, making sure that the holes in the skimmer and the gasket
are correctly aligned.
The liner must be installed within the following 48 hours. If this is not possible, defer mounting the
gasket until you are just about to fit the waterproofing membrane. The rest of the part (gasket and
flange) will be added after the liner has been fitted to ensure that the skimmer is leaktight.
7.1.2 Return fitting body
Working from inside the pool, push the return fitting body into the opening in the machined slat (Figure
Fasten it to the wall using 4 countersunk pozidrive wood screws, A4 SS (bag of screws enclosed with the
return fitting). Apply the self-adhesive gasket to the throughwall flange.
As in the case of the skimmer, the liner must now be fitted within the next 48 hours. If this is not
possible, delay application of the gasket until just before the waterproofing membrane is fitted.
The rest of the part (gasket and flange) will be added after the liner is fitted to ensure leaktightness at the
return fitting.
7.2

Assembling the filter

7.2.1 Preparing the valve

Unscrew and remove the ring. Remove the lid/valve
assembly (positioned upside-down during transport).
Glue the unions to the lid: the transparent union to the
waste outlet, and the black unions to the pump inlet
and outlet ports. As the drain union is transparent, the
visable portion will act as a turbidity sight glass.
To glue the unions in position, you will need PVC stripper,
a pot of rigid PVC glue (supplied), and medium grain sand
paper. Rub the male and female mating surfaces of the
components to be glued with sand paper, then stripper,
followed by a dry cloth. Spread a generous amount of
glue over the male and female mating surfaces, then
push the two parts to be glued together without twisting.
Wipe away excess glue with a clean cloth. Allow to cure
for 8 hours before exposing to water.
26/48
2021/02 - Version: D Code : 37311
Figure 24 – Mounting the return fitting body and gaskett
WOODEN POOLS BWT myPOOL POOL'N BOX
24).